To Program P.C:
Turn toggle switch to the on position. Press the “P”
button one time
Until the “Armed” L E D is flashing. Proceed
to set your desired “Start %”,
Using the arrow up and down directly below the “Start
%”window.
Proceed to program desired “Ramp Time” also
with arrow up and down.
Then press the “P” button until the “Armed”
L E D is steady green.
Now the P C is ready to be used.
Notice: cycle the toggle switch off then
on to ensure that P C has
Programmed correctly. Toggle needs to remain on in order
to
Operate
Modes of operation
Mode L E D off: When 12 volts is applied to the “ACT”
terminal the
“Start %” increases to 100 % and the “Ramp
Time” starts its ramp.
When 12 volts is removed “Start %”and “Ramp
Time” will reset
instantly.
Mode L E D on: When 12 volts is applied to the “ACT”
the “Start %”
increases to 100% and the “Ramp Time” starts
its ramp. When 12volts
is removed “Start %” and “Ramp Time”
will hold its value for 10 seconds.
Then it will reset to its original value, unless 12 volts
is reapplied within
10 seconds then it will continue its remaining “Start
%” and “Ramp Time”.
How to change Modes
Cycle Toggle switch on and press “P” once
until “Armed” L E D is
flashing. Then press “M” until the red L E
D is on or off depending
On what “Mode” user desires.
TESTING SYSTEM
Allow 5 minutes in-between testing of solenoid operation
to allow the
solenoids to cool down from dry runs. (no nitrous no fuel).
NOTE:
A nitrous redundant solenoid is recommended.
